UNITY AUTOMOTIVE 11100 Conjunto de puntal completo delantero 1998-2010 Volkswagen Beetle

They fit that's all I can say good about them I work in a shop they were professionally installed they were good for about 200mi now have crazy vibration in front end old struts didnd have any vibration alignment still checks out perfect

Fits well and works great

Good fit and decent performance On my VR6 Jetta. Bushings were slightly smaller than OEM and didn't Tighten/squish down all the way on install so I have a slight clunk over bumps that wasn't there in OEM struts. Need to Get a special sized washer to go under main bolt to squish bushings together more. All in all a decent inexpensive purchase.

0. Review based on a 2000 VW Golf GTI GLX, 126xxx miles on it, well maintained.1.These pre-assembled struts made a easy installation. The price are great, and the overall build quality are good (springs, strut. internal valves measured by riding quality).2. According to Bentley service manual, when install the front struts, impact wrench should be avoided. Using a special service tool and a hex bit on a torque wrench holding the inner stem, I want to tighten them to 44 lb ft. It turned out that the center stem broke. On the other side, I found the center stem can only hold up to 30 lb ft, beyond which it will strip. Without other choice, I used an impact wrench to tighten them (wired tool, thus strong).3. I live with them through the summer (3 months 1500 miles), and they feels fine …

My Jetta has just over 200,000 miles on it so I wasn't looking to spend a ton of money on struts. These fit the bill perfectly. Incredible price for being a complete strut, the shops around town wanted $75 for the strut itself without the spring, bushing, strut bearing, etc. Being a complete unit made installation so much easier.. Just a matter of putting the new strut in and bolting it down.Initially the struts make the front end sit a little bit high, and the struts come with a tag on them that say they will do that until the springs settle. Not a big deal to me, my old ones were so shot it looked like I had lowering springs in the front when in reality they were mismatched, well over 100,000 miles old and one of the springs had slipped over the top of the spring perch.Super happy with …

Install in our bug and they make a great difference. Almost half the cost of other brands and good product. will buy again

I bought these to replace the original struts in my '03 TDI with 210,000 miles on it. The old ones were probably fine but I had some noise in the front end (still there) and thought it couldn't hurt to replace them. These at around $60 each represent a great value and simplify the job of replacing struts greatly. Longevity will be the question but if they fail prematurely I will update this review. For now they ride just as the original strut and springs did and went in without any problem.The bottom of the strut that goes into the steering knuckle must be very slightly smaller than the originals. This is a benefit in that the original struts are much more difficult to get into and out of the knuckle. With the original struts you must wedge the knuckle pinch seam open very slightly to get

replacement strut parts VS the price of this complete unit.This saved time and money in the long run. Half the cost of a complete unit I could find at any local store or the web for that matter. Unit fit my jetta perfectly and ride is just as nice as new. 20 min job vs rebuilding the strut. extra 15 bucks well spent and I didn't need a spring compressor.