Conectores RJ45 8P8C de paso Cat 6

We have these things been my whole life wow they make fixing cables so easy

There is not a ton to say about these RJ45 pass through connectors other than that they work. I haven't had a bad one yet from the few I have used. It is just nice to get some ethernet connectors that are economical and also work well. Just make sure to have the wires lined up where you need them in A or B configuration and run the set up through a good Crimping Tool, then Voila. Your very own terminated CAT cable. 5 stars.

These RJ45 Cat6 pass-through connectors from Yiovvom are excellent. The pack of 50 offers great value, and the resealable bag helps keep everything organized between making new patch cables.I am new to using pass-through connectors compared to traditional closed-end ones, but with the right crimping tool, they save the step of trimming the conductors to an even length and eliminate the guesswork about wire insertion depth. I found these connectors easy to use and am pleased to have the right gear for pass-through crimping now.

I didn't have high expectations for these considering how inexpensive they were (compared to most other brands), but these have been a pleasant surprise. The tolerances may not be exactly like the more expensive kind, but I would definitely purchase these again.

I'm always on the lookout for high-quality connectors that are easy to use and reliable. That's why I was thrilled to discover these connectors. The connectors are specifically designed for Cat 6 cables and feature a pass-through design that makes termination simple. The transparent housing allows for easy visual inspection, ensuring proper wire alignment before crimping. Plus, they're compatible with both solid wire and standard cable, making them incredibly versatile. These connectors are a must-have for your networking projects.

Okay I'm older and my eyes aren't as good as they used to be. Wiring up a traditional connector is a struggle trying to see if my cross over lines are in the right slot and the appropriate depth. Why the heck didn't someone come up with this pass through connector sooner?!? Now that I have these in my kit, I've not had to re-terminate a single cable. The design removes all doubt for right slot and right length.Trust me, even if you're eagle-eyed this connector makes it idiot proof. That is until they build a better idiot.

I really hate putting a connector on a cable. You have align the wires so they go into the associated groove, which is a pain, but what makes it worse is getting the wires too long or too short and having to adjust. With these, just make the wires a bit too long, run them into the connector, then trim off the ends - perfect! Just alleviating that small part makes these so much better and easier to use.

I've always done all our home maintenance, including computer/network installation. Most of the work was done before fast & affordable wifi (or cheap, premade cables), so we have ethernet everywhere. Making up the RJ45 terminals was always a pain; it was always a struggle to get all the wires cut perfectly even and fully inserted in the terminal with the wire jacket perfectly placed for the terminal's strain relief to grab it. But these 'pass through' terminals make assembly a breeze. Just strip a little extra jacket, get the wires in the right order going into the terminal, and push until the jacket is under the strain relief. Crimp, clip the ends, and done. I may go back to making my own, correct length cables, instead of using pre-made stuff and having to deal with coiled up excess …